TM 9-2590-209-14&P
Section VIII. INSTALLATION OF MANFOLD TUBES AND GAURDS
b. Install two hose and seal assemblies to swivel
9-18. General. This section provided instructions for
assembly and union on manifold assembly (view B).
the installation of tubes and hoses to control valve
c. Slide tubes into slip joints and take up slack in
manifold and guards. Leave all protective caps and
front hoses.
covers on manifold tubes until tubes are ready for
d. Weld tubes at slip joints (view C).
installation.
NOTE
9-19. Hose Assemblies from Power Takeoff Pump
Tack weld tubes in position on
to Elbow (Fig 9-12).
a. Install hose, gasket, and two flanges, and secure
vehicle and lower tubes to make
with four screws and lockwashers (view A).
complete weld.
Replace tube in
b. Install hose, gasket, and two flanges, and secure
original position.
with four screws and lockwashers (view B).
e. Install drain plugs in slip joints (view C).
c. Tighten pump flange screws. Refer to figure 9-
9-21. Alteration and Installation of Blocks (Fig 9-
6, view B.
14).
9-20. Tubes and Hoses to Manifold Valve (Fig 9-
a. Alter blocks prior to installation (view A).
13).
b. Install' two blocks on hull and weld into position
CAUTION
(view B).
Before installing manifold tubes,
c. Install tube assemblies to blocks and secure two
remove protective covers and check
support tubes. Secure support tubes to blocks with four
screws, lockwashers, and washers (view B).
inside of all tube assemblies for dirt
or other contamination. Dirt or other
foreign material will cause damage to
the hydraulic system.
a. Install large and small tubes to hull and tighten
screws (view A).
9-17
