TM 9-2590-209-14&P
Figure 10-33. Installation of reservoir.
c. Install front guard as high as possible within
10-47. Installation of Cylinders and Ram Assemblies
limits of slotted holes. Secure guard with four screws,
a Install hoses and connections to cylinder (view
d. Install adjusting screws to position rear guard for
A).
tack welding lugs (view C). Adjust screws to center rear
guard (view C).
b Extend piston rod full stroke prior to installing
hoses to manifold (view B).
e. Install rear guard to mounting bracket (view C)
by tack welding the four lugs with rear guard as close to
c Install cylinder to mounting bracket with caps,
the hull as possible.
bolts, and lockwashers (view B).
f. Loosen adjusting screws and shake cylinder to
d Tilt cylinders back and forth. Adjust fittings to
check for clearance between guards, cylinders, and rear
the lower cylinder port to obtain the greatest amount of
guard. Remove front guard and complete welding three
travel (view A).
sides of each lug (view C).
e Install hoses from cylinder to manifold (view C).
g
Remove adjusting screws from guard and return
to spares.
h. Install guards and secure with attaching hardware
a Install front guard to cylinder with screws,
(view B).
washers, and lockwashers (view B).
i
Position two spacers between lower guard and
b Position rear guard over cylinder and ram
cylinder mounting bracket and secure guard and spacers
assembly, and install four screws, lockwashers, washers,
to mounting bracket (view D).
and lugs; hold guards in position (view A).
10-59