APPENDIX D
REPAIR PARTS LIST AND SPECIAL TOOLS
Section I. INTRODUCTION
Code
Explanation
D-1.
Scope
authorized for use at indicated maintenance
D-2.
This appendix lists repair parts and special tools
categories.
required for the performance of organizational, direct
"P2"
Repair parts which are procured and stocked
support, general support, and depot maintenance of the
for insurance purposes because the combat or
tank mounting, Earth Moving Bulldozer M8A3 as used
military essentiality of the end item dictates that
on an M48A3 tank.
a minimum quantity be available in the supply
D-3.
This Repair Parts and Special Tools List is
system.
divided Into the following sections.
"P9"
Assigned to items which are NSA design
controlled; unique repair parts, special tools,
composite listing of the repair parts, special tools, test
test, measuring and diagnostic equipment,
and support equipment having quantitative allowances
which are stocked and supplied by the Army
for initial stockage at the organizational level.
COMSEC logistic system, and which are not
subject to the provisions of AR 380-41.
authorized for the performance of maintenance at all
"P10"
Assigned to items which are NSA design
levels in figure and item number sequence.
controlled; special tools, test, measuring and
c. Special Tools, Test and Support Equipment
diagnostic equipment for COMSEC support,
which are accountable under the provisions of
equipment authorized for the performance of
AR 380-41, and which are stocked and supplied
maintenance at all levels.
by the Army COMSEC logistic system.
d. Federal Stock Number and Part Number Index
"M"
Repair parts which are not procured or stocked,
but are to be manufactured in indicated
numerical sequence followed by a list of part numbers in
maintenance levels.
ascending alpha-numeric sequence, cross-referenced to
"A"
Assemblies which are not procured to stocked
the illustration figure number and item number.
as such, but are made up of t% o or more units.
D-4.
Explanation of Columns.
Such component units carry individual stock
The following provides an explanation of
number &ad descriptions, are procured and
columns in the tabular lists in Sections II, III, and IV.
stocked separately and can be assembled to
a. Source, Maintenance, and Recoverability Codes
form the required assembly at indicated
(SMR), Column 1.
maintenance categories.
(1) Source code, indicates the selection status
"X"
Parts and assemblies which are n, procured or
and source for the listed item. Source codes are:
stocked and the mortality which normally is
Code
Explanation
below that , the applicable end item or
"P"
Repair parts which are stocked in or supplied
component.
The failure of such part of
from the GSA / DSA, or Army supply system
assembly should result in retirement of the end
and
item from the supply system.
AD-1
