TM 9-2590-506-13&P
Table 3-1. Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4.
LATCHES WILL NOT ENGAGE IN LOCK POSITION.
Check that converter assembly and tank opening are alined and the housing gasket is uniformly seated
completely around the tank opening.
a.
If converter assembly (1) and tank opening (2) are misalined, aline them.
b.
If any obstruction is preventing housing gasket (3) from seating around tank opening, remove obstruction.
c.
If latches will still not engage in lock position, notify direct support maintenance.
Check that levers (4) are in LOCK position.
a.
If in LOCK position, move to UNLOCK/DISENGAGE position and then back to LOCK position.
b.
If latches will still not engage in lock position, notify direct support maintenance.
TA255005
3-4