CLOSING THE TANK (Continued).
Remove vent line from vapor adaptor (1).
Install dust cover assembly (2) onto vapor
adaptor (1) by pushing straight down over vapor
adaptor until the latches (3) engage and then lift
latches to lock cover on adaptor.
Lift latch levers (1) up and over, towards center
of converter assembly (2).
Rotate latch levers (1) clockwise making sure
the locking latches (3) are disengaged.
Carefully lift converter assembly (2) straight out
of tank opening (4).
Carefully place converter assembly (2) on a
clean, flat surface.
Place manh ole cover over tank opening and
secure in place.
If converter assembly is to be reused to refuel
If converter assembly is to be stored, proceed to
2-10. PREPARING THE CONVERTER ASSEMBLY
FOR STORAGE AND SHIPMENT. If the converter
assembly is to be stored or shipped, proceed as follows:
Carefully lower converter assembly (1) into
bucket assembly (2).
Place nylon straps (3) over converter assembly
(1) and secure by engaging 2-bar buckles (4)
with end of nylon strap (3) and pulling until the
strap is tight.