TM 9-2590-506-13&P
5-18. JET SENSOR MAINTENANCE INSTRUCTIONS
(Continued)
(3) Remove two screws (9) and two washers
(10) and separate jet sensor (11) from
deflector bracket (7).
(4) Remove two male elbows (2) from jet
sensor (11).
CAUTION
During
cleaning,
use
only
compressed
air
to
dislodge
contamination from jets of jet sensor.
If the jet sensor is damaged, the
converter assembly will not operate
properly.
b. Cleaning.
Clean the jet sensor parts as
instructed in para 5-9.
c. Inspection.
Inspect jet sensor parts for
evidence of wear, contamination, nicks, burrs,
scratches or other damage.
d. Repair. Repair is limited
to replacement of
defective parts.
e. Installation.
(1) Install two male elbows (2) in jet sensor
(11).
(2) Position jet sensor (11) on deflector
bracket (7) and install two screws (9) and
two washers (10). Tighten screws to 90 to
112 pound-inches.
(3) Using holes marked d ring removal (see
u
NOTE after para 5-18.a.(1)), place
deflector bracket (7) on extension (8) and
install two screws (6), two washers (5) and
two nuts (4). Tighten nuts to 90 to 120
pound-inches.
TA255035
5-26
