ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-14E
Section Il. SERVICE UPON RECEIPT
Page
Paragraph
Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-2
Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-2
Testing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-2
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report
the damage on SF Form 364, Report of Discrepancy (ROD).
b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA PAM 738-750.
c. Check to see whether the equipment has been modified.
4-5. Lubrication. Refer to LO
9-2805-259-12 and perform
unit level and operator level lubrication on
engine.
4-6. Testing. Perform
unit level PMCS, and operator Before (B) PMCS before starting
engine. Start
engine,
para. 2-9, and run for at least 15 minutes. Observe
the engine during operation. If
any malfunctions arise,
Section III. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
Page
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-2
PMCS Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-2
4-7. General. Unit level maintenance
PMCS are done to ensure
that the engine is in
top operating condition.
A comprehensive PMCS program reduces equipment downtime and increases the operational readiness of the
engine.
4-8. PMCS Procedures. Unit level
PMCS is
contained in
table 4-1. The numbers in
the Item No.
column
show the order in which the check or service should be done. These numbers should be used when recording
deficiencies and shortcomings on DA Form 2404, Equipment Inspection and Maintenance Worksheet. The dot ()
in the Interval column indicates when a check or service should be done, as follows: