TABLE EXTENSION BARS
(Air powered table only)
The table extension bars provide adjustable
outboard support for plate of flat stock
larger than the table. The bars can be locked
in any position in the table T slots. Studs at
the ends of the bars serve as backstops for
straight or irregular pieces at any angle.
FILE ADAPTER PLATE (Air powered table only)
By using this file adapter plate, accurate filing of small work is possible. It also acts as a
safety device, since it prevents jamming of the work between the table slot and the face of
the file band.
(1)
Remove the table center plate and install
the special file adapter plate around the
file band.
(2)
Loosen the flat head screws in the top
plate and adjust to within 1/16 in. of the
cutting surface of the file band. Tighten
the flat head screws.
DETACHABLE BALL TRANSFER STRIPS (Air powered table only)
For a large or heavy workpiece, use the ball transfer
strips. The two center strips should be attached to
the table with screws as shown here. The other
strips can be moved about as required during sawing.
NOTE: Using the ball transfer strips reduces work
height capacity 1-1/2 inches.
30
