APPENDIX H
CHAPTER 1
INSTALLATION
LOCATION
Locate the welder so that the operator will have sufficient room for
handling and welding saw bands. Space should be allowed so that the
coiled band will not injure persons passing nearby. The welder should
also be located so that the welding sparks will not ignite flammable
material.
ELECTRICAL CONNECTIONS (PORTABLE ONLY)
The welder must be connected to an electrical power line of sufficient
capacity to provide for the instantaneous load specified on the data plate.
The welder should be fused according to the amperage on the data plate.
Refer to the wiring diagram supplied with the welder. The welder will
not operate on direct current.
The welder may be installed on band sawing machines. The location is convenient
for welding bands to fit over two or three band wheels of saw. Correct band length
for the machine is stamped on a data plate attached to the rear of the machine column.
H-1
