TM 9-3405-215-14&P
LUBRICATION CHART
LUBRICATION
LOCATION DESCRIPTION AND
LUBRICATION
RECOMMENDED
POINT NUMBER
SERVICE RECOMMENDATIONS
INTERVAL *
LUBRICANT
1
Sand Tension Screw and Bearing.
MONTHLY
Clean and apply oil.
2
Post, Post Elevation Screw and Gears.
MONTHLY
Clean and apply oil.
3
Upper Wheel Slide, Hinge and Tilt Screw.
MONTHLY
Clean and apply oil.
4
Table Trunnion. Oil tilt surfaces.
MONTHLY
High quality, rust and oxidation
Transmission. 1 quart (0.95-liter) capacity.
inhibited, medium hydraulic and
5
Proper oil level must be maintained. Drain
AS REQUIRED
general purpose industrial oil.
and refill yearly or when required.
ASTM Grade No. 315.
6
Transmission Shift Linkage and Interlock.
AS REQUIRED
Clean and apply oil as required.
7
Miscellaneous, Hinges, Pivot, etc.
CHECK MONTHLY
Clean and apply oil as required.
Accessory Equipment as Supplied.
8
Keep clean and apply oil as required to
CHECK MONTHLY
maintain proper function and reduce wear,
corrosion, etc.
(For 80 degrees F and above).
High quality, rust and oxidation
Air Compressor (Optional).
inhibited, medium hydraulic and
9
Proper oil level must be maintained. Drain and
general purpose industrial oil
refill every 3 months. Keep crankcase and
CHECK WEEKLY
air intake filter clean.
ASTM Grade No. 465.
Premium quality, multi-purpose,
lithium base, EP (extreme
10
Grease Fittings and Miscellaneous
CHECK MONTHLY pressure) grease.
applications (Optional).
AS REQUIRED NLGI Grade No. 2
Dry, powdered lubricating
Air Pump (Optional). Remove air intake
CHECK MONTHLY graphite
11
filter. Feed lubricant into opening while
AS REQUIRED (natural or manufactured).
pump is in motion. Keep air filter clean.
graphite lubricant.
12
Electric Motor(s).
Lubricate as required per manufacturer's recommendations.
13
DBW-15 Welder
Lubricate as required per DBW-15 Instruction Manual.
Premium quality, saw band
14
Drip or Mist Coolant Tank (Optional).
CHECK DAILY
coolant and lubricant.
1 quart (0.95 liter) capacity. Keep filled.
AS REQUIRED
cutting fluids and/or oils.
Lubrication intervals are based on an 8-hour day, 40-hour week. Lubricate more often when required.
13
