INSTALLATION OF THE MACHINE
1. Assembly Machines are shipped completely
assembled - ready to go to work. Should special
equipment be ordered it will be shipped completely
assembled with any instructions necessary. If domestic
pack (slats) was used small items ordered will be
wrapped in a sealed carton placed in the reservoir tank.
When the machine has been placed in the desired
position, the hone base pedestal should be shimmed at
the lowest point on the floor to steady it if necessary. Do
Not Tilt The Machine To Make The Spindle Run At
Horizontal. The spindle slopes to make the operator's
job easier and to give a better flow of oil through the
workpiece.
2. Honing Oil System. Fill resevoir tank (holds 12
gallons). Use a good grade of honing oil. Cutting or
water soluble oils are not satisfactory. They may cause
galling, scoring, and stone glazing, etc.
