TM9-4110-254-14
(9)
Install clamps (13) and (16), bolt (12), new lock washer (11) and new self locking nut (10)
(10) Install sensing bulb bracket (9), two flat washer (8), new lock washers (7), and bolts (6)
(11) Install cover (5) and screw (4)
(12) Close control panel (3) Install two new lock washers (2) and bolts (1)
b
Removal
(1)
Be sure power has been disconnected at the source and remove two bolts (1) and lock washers (2) Open
control panel (3) Discard lock washers
(2)
Remove screw (4) and cover (5)
(3)
Remove two bolts (6), lock washers (7), flat washers (8), and sensing bulb bracket (9) Discard self locking
nuts and lock washer
(4)
Remove self locking nut (10), lock washer (11), bolt (12), and sensing bulb bracket (9) Discard self locking
nut and lock washer
(5)
Remove clamps (13)
(6)
Tag wire leads (17), then remove two screws (18) and wire leads
(7)
Pull wire leads (17) from remote bulb thermostat (15) and remove grommet (19)
(8)
Remove tie down straps (20).
(9)
Remove four self locking nuts (21), bolts (22), and flat washers (23) Discard self locking nuts
(10) Remove remote bulb thermostat (15) and any grommets (24) and (25) necessary to remove sensing bulb
(14)
(11) If temperature control switch bracket (26) is damaged, remove two self locking nuts (27), flat washers
(28), screws (29), and bracket. Discard self locking nuts
(12) Remove any silicone RTV remaining m grommets (24)
c
Installation
(1)
If removed, install temperature control bracket (26), two screws (29), flat washers (28), and new self
locking nuts (27)
(2)
Install remote bulb thermostat (15) routing sensing bulb (14) through grommets (24) and (25) Install any
grommets removed.
(3)
Install remote bulb thermostat (15), four flat washers (23), bolts (22), and new self locking nuts (21)
(4)
Install tiedown straps (20) as necessary.
(5)
Install grommet (19) and push wire leads (17) into remote bulb thermostat (15)
(6)
Using tags and wiring diagram (fig 1-4), install wire leads (17) and two screws (18) Remove tags
4-71
