TM 9-4120-371-14
b. Removal
(1) Tag and disconnect wire leads.
(2) Using screwdriver and wrench, remove four screws and nuts from terminal board (TB2).
(3) Using screwdriver, remove four screws and flat washers from terminal board (TB1).
(4) Remove terminal boards.
c. Installation
(1) Using screwdriver, secure terminal board (TB1) with four screws and flat washers.
(2) Using screwdriver, pliers, and wrench, secure terminal board (TB2) with four each screws and nuts.
(3) See tags and wiring diagram (fig. 4-23) and connect wire leads.
(4) Remove tags
Follow-on procedure: Install junction box cover and lower front panel. (See para 4-48.)
Preliminary procedure: Remove junction box. (See para 4-47.)
a. Access
(1) Using screwdriver, loosen four captive panel fastener screws in junction box cover.
(2) Remove cover.
