TM 9-4120-378-14
4.24 CONTROL MODULE. - Continued
Remarks
Action
Location/Item
Crimp required contacts on appropriate wire
h.
Replacement
ends.
- Continued
Print wire identification number on shrink sleev-
i.
ing and shrink on appropriate wire end.
Solder wire to appropriate connector pin.
j.
k.
Straighten and clean any bent or dirty pins on
connector plug.
l.
Replace connector plug with leads.
Control Module
Wiring Harness
a.
Install connector with leads (41 ) into back plate
Installation
(14).
b.
Connect leads and disconnect tags.
c.
Install seven screws (38), seven flat washers (39)
and seven locknuts (40) and secure connector to
back plate.
d.
Install screw (16), flat washer (18), post spacer
(19), locknut (17), and clamp (20) and secure
Temperature Selector switch sensing line to back
plate (14).
Circuit Breaker
Slide switch (37) into front plate (13) through
a.
Installation
backside.
b.
Attach switch using four screws (35) and four flat
washers (36).
c.
Aline middle section of throw switch and insert
pin.
d.
Connect leads and remove tags.
Mode Selector
Switch
a.
Slide switch (34) into front plate (13) through
Installation
backside.
b.
Attach switch (34) using lockwasher (33) and
mounting nut (32).
4-51
