TM 9-4120-378-14
HOUSING-REPAIR.- Continued
6.2
Remarks
Action
Location/Item
Repair
d. Coat the attaching side with adhesive, using a
paint brush to ensure complete coverage.
. Continued
e. Coat the metal with adhesive to which the insula-
tion is to be attached.
f. Let both surfaces air-dry until the adhesive be-
comes tacky but will not stick to the fingers.
g. Starting at one corner or at a narrow edge, care-
fully bring the insulation into full contact with the
metal.
h. Press into firm contact all over.
i. Allow sufficient time to dry thoroughly before
installation.
Housing
a. Visually inspect for nicks, gouges, dents, bare
spots in paint and other defects which can be re-
paired.
Repair
b. Repair/replace handles and associated hardware.
c. Sand and paint any repaired area in housing, ref-
erencing TM 43-0139, Painting Instructions for
Field Use.
d. Remove minor dents, and paint.
e. Remove any rust or other minor corrosive dam-
age, and paint.
6-3/(6-4 blank)
