TM 9-4120-388-14
5-5. EVAPORATOR AND CONDENSER FAN MOTOR (B2) REPAIR - Continued.
(g) See wiring diagram and tags and solder leads to new connector.
(h) Remove tags.
(i) Secure connector to terminal box with four screws.
(j) Secure terminal box to motor with four screws.
(2) To replace connector (J12) (lMC):
(a) Remove four screws and flat washers from connector (J12).
(b) Pull connector away from frame as far as wires will allow.
(c) Tag and unsolder leads.
(d) Remove old connector.
(e) See wiring diagram and tags and solder leads to new connector.
(f) Remove tags.
(9) Secure connector to frame with four screws and flat washers.
(3) To replace thermostat (thermal protector) (Welco only):
(a) Remove four screws from terminal box.
(b) Pull terminal box away from motor as far as connectors will allow.
(c) Remove two screws and spacers.
(d) Pull thermostat away from motor.
(e) Tag and disconnect leads to the thermostat.
(f) Remove old thermostat.
(g) See tags and connect leads to new thermostat.
(h) Remove tags.
