TM 9-4120-388-14
5-24. EVAPORATOR COIL.
For inspection and cleaning of installed coil, (See para 4-64).
This task covers:
a. Removal
b. Repair
c. Installation
INITIAL SETUP:
Equipment Condition
Removal.
a.
(1) Be sure that power has been disconnected.
(2)
Lift mist eliminator straight up and out of guides.
(3)
(4)
NOTE
Tube at bottom of evaporator header and elbow at bulkhead are most likely disconnect
points.
While purging the system with nitrogen, debraze the tube joints to the evaporator. (See para 5-8 and 5-9.)
(5)
(6)
Remove four screws and remove two side panel inserts.