TM 9-4120-388-14
6-4. LIFTING HANDLES.
b. Installation
This task consists of:
a. Removal
INITIAL SET-UP:
Equipment Condition
Junction box removed (4-46).
Liquid quench expansion valve removed (Only if left handle and enclosure are to be removed) (5-20)
Removal.
a.
(1) Remove six screws and nuts from each handle and enclosure.
(2) Remove handle(s) and enclosure(s).
(3) If bracket on left enclosure is to be replaced:
(a) Use a drill slightly smaller than the diameter of the rivet body to drill out the four rivets.
(b) Secure the new bracket with four rivets.
b. Installation.
(1)
Place the handle(s) on the outside and the enclosure(s) on the inside of the casing side panel(s).
(2)
Align mounting holes.
(3)
Secure the handle(s) and enclosure(s) with six screws and lock nuts (each handle).
Install liquid quench expansion valve. (Only if left handle and enclosure were removed.) (See para 5-20.)
(4)
