TM9-4120-401-14
5-8. LOGIC BOX ASSEMBLY (LGC1). - continued
(h) Place S5 in the ON position for 2 seconds and then place S5 in the OFF position. The following
routine shall occur:
1 LED 2 shall turn off and LED 7 shall remain illuminated.
2 For the next 8 seconds: LED 5 illuminates. LED 7 remains illuminated.
3 For the next 2 seconds: LEDs 5 and 7 turn off.
4 LED 7 illuminates for 2 seconds and then turns off for 2 seconds.
5 LEDs 2 and 7 shall illuminate. End of routine.
(i) Place S6 in the ON position for 2 seconds and then place S6 in the OFF position. The following
routine shall occur:
1 LED 2 shall turn off and LED 7 shall remain illuminated.
2 For the next 8 seconds: LED 6 illuminates. LED 7 remains illuminated.
3 For the next 2 seconds: LEDs 6 and 7 turn off.
4 LED 7 illuminates for 2 seconds and then turns off for 2 seconds.
5 LEDs 2 and 7 shall illuminate. End of routine.
Place S1 in the ON position for 2 seoonds and then place S1 in the OFF position. LEDs 2 and 7
(j)
shall turn off for 10 seconds then LEDs 2 and 7 shall illuminate.
(k) Place S1 in the ON position. LEDs 2 and 7 shall turn off. In 10 seconds LED 3 shall illuminate.
Place S1 in the OFF position and reset MODE switch by turning to OFF/RESET. Turn MODE switch
(l)
back to COOL position. In 2 seconds LEDs 2 and 7 shall illuminate.
(m) Place S1 in the ON position. LEDs 2 and 7 shall turnoff. In 10 seconds LED 3 shall illuminate.
(n) Place S1 in the OFF position, LED 3 remains illuminated.
(o) Place switches S1 through S6 in the OFF position. Reset MODE switch by turning to OFF/RESET
and back to COOL position. Place S4 in the ON position. After 1 second, place S1 in the ON
position. LED 4 shall illuminate. After S1 is placed in the ON position, LED 4 shall turn off. In 10
seconds LED 3 shall illuminate.
(p) Reset MODE switch by turning to OFF/RESET position. Do not change any other switch positions.
Turn MODE switch to COOL position. No LEDs shall illuminate. In 10 seconds LED 3 shall
illuminate.
(q) Reset MODE switch by turning to OFF/RESET position. Do not change any other switch positions.
Turn MODE switch to COOL position. Then immediately place S4 and S1 in the OFF position. In 10
seconds LEDs 2 and 7 shall illuminate.
(r) Place S2 in the ON position. LEDs 2 and 7 remain illuminated. S2 has no effect.
5-20
