TM 9-4120-402-14
4-25. MIST ELIMINATOR. - continued
WARNING
Dry cleaning solvent used to clean parts is potentially dangerous to personnel
and property. Do not use near open flame or excessive heat. Use in well
ventilated area.
b. Clean.
(1) Immerse mist eliminator (1) in a mild detergent solution or dry cleaning solvent.
(2) Agitate until dirt is removed, using a sofbrush if necessary to loosen caked-on dirt.
t
(3) Rinse in clear water or dry cleaning solvent.
(4) Drain, then hold mist eliminator (1) horizontally and tap each edge on bench or floor to dislodge droplets.
(5) Be sure mist eliminator (1) is totally dry prior to installation.
c.
Inspect.
(1) Check mist eliminator (1) for punctures, cuts, and damaged edges that would allow air to bypass.
(2) Check mist eliminator (1) for packed or mashed areas that would block air flow.
(3) Replace mist eliminator (1) if found bad.
d. Install.
Slide mist eliminator (1) straight down into guides with UP marking pointing up and directional arrow pointing out
away from unit.
NOTE
FOLLOW-ON MAINTENANCE:
Install top panel (para 4-19).
Connect power at power source.
4-82
