TM 9-4120-402-14
5-8. LOGIC BOX ASSEMBLY (LGC1). - continued
(o) Place S5 in the OFF position. Reset previous fault condition by turning the MODE switch to OFF/RESET
position and then back to HEAT position. Place S4 in the ON position for 2 seconds and then turn S4 OFF.
The following routine shall occur:
1
LED 1 shall turn off and LED 7 shall remain illuminated.
2
For the next 8 seconds: LED 4 illuminates. LED 7 remains illuminated.
3
For the next 2 seconds: LEDs 4 and 7 turn off.
4
LED 7 illuminates for 2 seconds and then turns off for 2 seconds.
5
LEDs 1 and 7 shall illuminate. End of routine.
(p) Place S5 in the ON position for 2 seconds then place S5 in the OFF position. The following routine shall occur:
1
LED 1 shall turn off and LED 7 shall remain illuminated.
2
For the next 8 seconds: LED 5 Illuminates. LED 7 remains illuminated.
3
For the next 2 seconds: LEDs 5 and 7 turn off.
4
LED 7 illuminates for 2 seconds and then turns off for 2 seconds.
5
LEDs 1 and 7 shall illuminate. End of routine.
(q) Place S6 in the ON position for 2 seconds then place S6 in the OFF position. The following routine shall occur:
1
LED 1 shall turn off and LED 7 shall remain illuminated.
2
For the next 8 seconds: LED 6 illuminates. LED 7 remains illuminated.
3
For the next 2 seconds: LEDs 6 and 7 turn off.
4
LED 7 illuminates for 2 seconds and then turns off for 2 seconds.
5
LEDs 1 and 7 shall illuminate. End of routine.
(r)
Place S2 and S4 in the ON position making certain that S2 is completed before S4. LED 1 turns off and LED 7
remains illuminated. In 10 seconds LEDs 3 and 4 shall illuminate and LED 7 remains illuminated.
(s) Reset by placing S2 and S4 in the OFF position and turning the MODE switch to OFF/RESET and back to
HEAT. Place S2 and then S5 in the ON position making certain S2 is completed before S5. LED 1 turns off
and LED 7 remains illuminated. In 10 seconds LEDs 3 and 5 shall illuminate and LED 7 remains illuminated.
(t)
Reset by placing S2 and S5 in the OFF position and turning the MODE switch to OFF/RESET and back to
HEAT. Place S2 and then S6 in the ON position immediately after. LED 1 turns off and LED 7 remains
illuminated. In 10 seconds LEDs 3 and 6 shall illuminate and LED 7 remains illuminated.
5-16