TM 9-4120-403-14
Removal
(1) Remove four screws, washers, and lockwashers from J8 connector.
(2) Remove locknut, lockwasher, and flat washer from grounding screw.
(3) Tag and disconnect leads from switches.
(4) Remove harness.
(5) Remove gasket behind J8. Check for tears.
Repair
(2) See table 4-3 (Wire List) for wire lengths and terminal information when individual wires are replaced.
Installation
(1) Install harness and gasket.
(2) Secure connector J8 (keeping keyway pointing upward) and gasket to box with four screws, washers, and
(3) Secure ground wire to grounding screw with flat washer, lockwasher, and locknut.
(4) See tags and wiring diagram (fig. 4-43) and reconnect leads.
(5) Remove tags.
(7) Insert rear panel into box and aline holes.
(8) Secure rear panel with four screws and locknuts.
(9) Place TEMPerature control thermostat knob on shaft and tighten setscrews.
Follow-on procedure: Install control panel. (See para 4-26.)
4-68