TM 9-4120-405-13&P
Section II. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND
SUPPORT EQUIPMENT
4-3. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
4-4. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. No special tools are required for maintenance of the
equipment. Test, Measurement, and Diagnostic Equipment (TMDE) and Support Equipment include standard equipment
found in any maintenance shop.
4-5. REPAIR PARTS. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),
Appendix C, for the trailer-mounted, generator-set-powered, air conditioner. Refer to the following manuals for RPSTLs
on individual components:
Air Conditioners
TM 5-4120-384-24P
Generator Set
TM 5-6115-585-24P
Trailer
TM 9-2330-202-14&P
Section III. SERVICE UPON RECEIPT AND PREPARATION FOR MOVEMENT
4-6. SERVICE UPON RECEIPT. The following paragraphs contain the procedures for unpacking and general checking
of the unpacked trailer mounted, generator-set powered, air conditioner.
4-7. UNPACKING THE EQUIPMENT. Trailer mounted, generator-set powered, air conditioners shipped within the
continental United States will usually not be boxed or crated, but will usually be boxed or crated for overseas shipment. If
boxed/crated, unpack the equipment as follows:
a.
Remove and set aside packing list and shortage packing list (if applicable) from side of box/crate.
WARNING
Steel strapping used in packaging of the equipment has sharp edges and may be
under load or tension. To avoid injury to personnel, use care when handling steel
strapping.
b. Using metal cutters while standing so you are not in line with strapping, carefully cut the steel strapping around
the box/crate. Remove the box/crate from trailer.
c. If accessories are boxed separately, open box in which they are packed and remove all packaging/cushioning
material.
4-6
