TM 9-4120-407-14
(14) Check ball bearings (12) and (13) for any damage such as binding or looseness and any evidence of
overheating such as discoloration. Replace if damaged.
b. Repair. Repair is limited to replacement of defective or damaged parts.
c. Assembly.
(1) Carefully install thermostat (15) into winding (16) in location noted during disassembly.
(2) Install two new spring tension washers (14) and ball bearing (13) into end shield (3).
(3) Install ball bearing (12) into end shield (2).
(4) Carefully push cords (8) through end shield (3).
(5) Carefully install contacts (10) into connector bodies (11) per tags and wiring diagram Figure 3-5.
Remove tags.
(6) Install cord bushing (9).
(7) Align match mark made during disassembly and carefully assemble end shield (3) onto frame (1).
Gently tap end shield into place.
(8) Carefully install rotor (7).
(9) Align match mark made during disassembly and carefully assemble end shield (2) onto frame (1).
Gently tap end shield into place.
(10) Install four studs (6), new lock washers (5) and nuts (4).
NOTE
FOLLOW-ON MAINTENANCE:
4-23