TM 9-4120-407-14
(3)
Air Duct Hose Installation.
NOTE
Two clamps secure air duct hose in place. Installation instruction are
typical for each clamp.
( a ) Install duct (42), four screws (39), new lock washers (40), and flat washers (41).
(b) Install collar (38), screw (35), new lock washer (36), and flat washer (37).
(c) Install air duct hose (34).
(d) Install two clamps (33), screws (30), new lock washers (31), and flat washers (32)
(4) EMI Suppressors (FCZ through FC4) Installation..
(a) Attach two new tape strips (29).
(b) Install two core halves (28) and close case (27).
(c) Secure case (27) with new tiedown strap (26).
(5) Motor Controller Installation.
(a) Install enclosure per step (1) above.
(b) Install motor controller (25).
(c) Install two screws (22), new lock washers (23), and flat washers (24).
(d) Connect connectors (20) and (21) per tags and wiring diagram Figure 3-5. Remove tags.
(e) Connect wire leads (18) onto terminal board (19) per tags and wiring diagram Figure 3-5.
Remove tags.
(f) Install two posts (17), one cover (16), two screws (13), new lock washers (14), and flat
washers (15).
(g) Install two new tiedown straps (12).
( h ) Install cover (11), six screws (8), new lock washers (9), and flat washers (10).
( i ) Install two screws (5), new lock washers (6), and flat washers (7).
(j) Remove shield (4), two screws (1), new lock washers (2), and flat washers (3).
NOTE
FOLLOW-ON MAINTENANCE:
Install electrical components bracket and rain shield sheet. See para 3-28.
4-20