TM 9-4120-408-14
4-16. CONDENSER WIRING HARNESS MAINTENANCE.
This task covers:
Remove
Repair
Test
INITIAL SETUP:
Tools
Materials/Parts (Continued)
Tool Kit, Service Refrigeration Unit,
Gasket, Appendix G, Item 9 (A104J2)
Lock Washers, Appendix G, Item 12
Crimping Tool, Appendix B, Section III,
(A104J1)
Item 3
Lock Washers, Appendix G, Item 13
Heater, Gun Type, Electrical,
(A104J2)
Lock Washers, Appendix G, Item 14
Material/Parts
(Cable Clamps)
Refer to TM 9-4120-408-24P for part
Cable Clamp Electrical, Appendix E, Item 7
numbers of items to be replaced.
(A104J1)
Equipment Conditions
Adapter, Cable Clamp, Appendix E, Item 1
(A104J2)
Air Conditioner shut down,
Insulation Sleeving, Appendix E, Item 13
(A104J1)
Condenser Side Panel removed, paragraph
Insulation Sleeving, Appendix E, Item 12
4-11.
(A104J2)
General Safety Instructions
Insulation Sleeving, Appendix E, Item 15
Do not work on equipment without
following standard shop safety
Strap Tiedown, Appendix E, Item 26
procedures.
Tags, Appendix E, Item 27
Ensure that power has been disconnected
before performing maintenance on
Gasket, Appendix G, Item 10 (A104J1)
electrical components.
NOTE
This procedure applies to wiring harness A104J1.
The procedure for wiring harness A104J2 is
similar.
a. Remove.
WARNING
Do not work on equipment with power connected. Electrocution hazard is present. Failure to obey
this warning may result in death or serious personal injury.
(1) Refer to Appendix H, Figure H-2, Tables H-3 and H-4, and tag and disconnect all single wire terminations
for wiring harness A104J1 (Figure 4-10, 1) and remove and discard all tiedown straps.
(2) Remove two screws (2), lock washers (3), flat washers (4), and cable clamps (5). Discard lock washers
(3).
4-21
