TM 9-4120-408-14
4-16. CONDENSER WIRING HARNESS MAINTENANCE. (Continued)
(3) Remove wiring harness A104J2 (6) from cable clamp (5).
(4) Remove four nuts (7), lock washers (8), flat washers (9), screws (10), one electrical receptacle cover (11),
gasket (12), and connector (13) of wiring harness A104J1 (1). Discard lock washers (8) and gasket (12).
b. Inspect.
(1) Inspect for loose wires in connector (13).
(2) Inspect all wiring harness (1) wires for cracked insulation, damaged or missing connectors and terminals,
burns, or fraying.
(3) Inspect grommets (14) for damage.
(4) Inspect all mounting hardware for damage.
harness A104J1 (1).
NOTE
d. Repair.
(2) Replace all damaged or defective components.
e. Install.
(1) Install connector (13), new gasket (12), electrical receptacle cover (11) and secure with four screws (10),
flat washers (9), new lock washers (8), and nuts (7).
(2) Insert wiring harness A104J2 (6) into cable clamp (5).
NOTE
Position larger cable clamp on vehicle rear side of condenser assembly.
(3) Install two cable clamps (5) and secure with two flat washers (4), new lock washers (3), and screws (2).
harness A104J1 (1). Secure wiring harness A104J1 (1) with new tiedown straps approximately every three
inches. Remove and discard tags.
(5) Follow on maintenance: refer to paragraph 4-11 and install side panel.
4-23