TM 9-4120-408-14
4-24. CONTROL MODULE WIRING HARNESS MAINTENANCE.
This task covers:
Remove
Repair
Inspect
Install
Test
INITIAL SETUP:
Tools
Equipment Conditions
Tool Kit, Service Refrigeration Unit,
Air Conditioner shut down,
Power disconnected, refer to applicable
Crimping Tool, Terminal, Appendix B,
technical manual.
Section III, Item 3
Control Module Top Panel removed,
Material/Parts
Tiedown Strap, Appendix E, Item 26
General Safety Instructions
Tags, Appendix E, Item 27
Do not work on equipment without
Gasket, Appendix G, Item 9 (A105J1)
following standard shop safety
procedures.
Gasket, Appendix G, Item 10 (A105J2)
Ensure that power has been disconnected
before performing maintenance on
Lock Washers, Appendix G, Item 12 (AlO5J1)
electrical components.
Lock Washers, Appendix G, Item 13 (A105J2)
Refer to TM 9-4120-408-24P for part
WARNING
numbers of items to be replaced.
Do not work on equipment with power
connected. Electrocution hazard is
present. Failure to obey this warning
may result in death or serious personal
injury.
NOTE
This procedure applies to wiring harness A105J2. The procedures for wiring harness A105J1 are similar.
a. Remove.
WARNING
Do not work on equipment with power connected. Electrocution hazard is present. Failure to obey this
warning may result in death or serious personal injury.
(1) Refer to Appendix H, Figure H-1, Tables H-1 and H-2, and tag and disconnect all single wire terminations for
wiring harness A105J2 (Figure 4-18, 1).
(2) Remove four nuts (2), lock washers (3), flat washers (4), screws (5), connector (6) of wiring harness A105J2 (1),
and gasket (7). Discard lock washers (3) and gasket (7).
4-39
