TM 9-4120-408-14
4-24. CONTROL MODULE WIRING HARNESS MAINTENANCE. (Continued)
e. Install.
(1)
Install new gasket (7) and connector (6) in control module (8) and secure with four screws (5), flat washers (4),
new lock washers (3), and nuts (2).
(2)
Refer to Appendix H, Figure H-l, Tables H-1 and H-2 and connect all single wire terminations for wiring harness
A105J2 (1). Remove and discard tags.
(3) Follow on maintenance:
(a) Refer to applicable technical manual and connect power.
(b) Refer to paragraph 4-20 and install control module top panel.
4-25. CONTROL MODULE ELECTRICAL LEAD, DIODE, AND RESISTOR ASSEMBLIES MAINTENANCE.
This task covers:
Remove
Repair
Inspect
Install
Test
INITIAL SETUP:
Tools
Equipment Conditions (Continued)
Tool Kit, Service Refrigeration Unit,
Control Module Wiring Harnesses A105J1
and A105J2 disconnected as required,
Soldering Iron, Appendix B, Section III,
Item 5
General Safety Instructions
Material/Parts
Do not work on equipment without
following standard shop safety
Solder, Appendix E, Item 23
procedures.
Tags, Appendix E, Item 27
Ensure that power has been disconnected
before performing maintenance on
Refer to TM 9-4120-408-24P for part
electrical components.
numbers of items to be replaced.
Equipment Conditions
WARNING
Air Conditioner shut down,
Do not work on equipment with power
connected. Electrocution hazard is
Power disconnected, refer to applicable
present. Failure to obey this warning
technical manual.
may result in death or serious personal
injury.
Control Module Top Panel removed, paragraph
4-41
