9.
From inside filter sleeve remove two hex head plugs. Valve springs will drop out when plugs are removed. Tap
valve stems (CL-92) on rounded end to remove from hex plug end of valve hole.
10. Assemble new valve assembly (CL-92) in casting and reassemble other cleaner components. Use supplied packing
gland material when required.
11. Be sure to tighten packing glands at rounded end of valve stems until valve returns slowly when depressed. Then
back off gland 1/4 turn.
FILTER SLEEVE REPLACEMENT
1.
Follow procedure under Valve Replacement, Item 1 through 7.
2.
Remove copper air line and elbow from casting.
3.
Loosen and remove upper (CL-105) and lower clamp (CL-86) assemblies and slide filter sleeve (CL-88) up and off.
4.
Slide new filter sleeve into position, tighten clamps. Reassemble other cleaner components.
12
