(c) Stop the varidrive assembly by de-
points of both the overload circuit
pressing the "STOP" button (21-C)
b r e a k e r device and circuit breaker
o n the drive control (21) and re-
r e l a y unit (cut-out relay) (figs. 33
m o v e the generator and generator
or 35) are open. Observe the ampere
r e g u l a t o r from the test stand and
reading on the load dc ammeter (1)
s e c u r e the cover on the regulator.
when both sets of points are open.
Place switches and controls in table
The ampere reading should be at
4 above in positions indicated in
approximately 32 amperes.
column 3b of the table.
Caution: Do not perform this
test more than is necessary, as it
o n other models of generator regulators.
causes high arcing across the points
Refer to TM 9-1825B (Auto-Lite) and
of the circuit breaker relay unit
TM
9-8627
(Delco-Remy)
for
further
(cut-out relay).
i n f o r m a t i o n when performing tests.
73
