TM
9-4910-609-14&P
5.4
Reassemble (Continued)
Action
2.
Tighten Item 5-4.
1.
Insert rotating shaft, Item 4-1.,
Overhanging Arm, Item 4
through guiding hole of Item 3,
insert retaining ring, Item 3-2.
Drive Guide, Item 3
1.
Locate drive-quide on top of actuator.
2.
Insert Item 1-6 into actuator.
Tighten Item 1-8 (2 places)
3.
Tighten Item 1-10 (2 places)
4.
Place and secure reservoir to the base,
Reservoir, Item 2
1.
Item 1, using (4) ea bolts and
washers, Items 2-4 and 2-3.
2.
Connect tubing, Item 2-8. Tighten
nuts at each end.
Place clamp assemblies, Item 5-6,
Clamping
Fixture
Item
5
1.
(2) on the clamping fixture,
Item 5, with pads, Item 5-7-3,
facing each other.
2.
Insert clamp traveler bar, Item
5-2, through the end hole of
Item 5 and through the holes on
the clamp assemblies, Item 5-6,
and through the other hole in
Item 5.
Secure Item 5-2 with the set
3.
screw, Item 5-3 (2).
10
