6. Work Head Stop Pin - place in reamed holes for desired degree
setting on table back of work head base. Round side against
work head for accurate angle, i.e. 450; flat side against work
head for minus 1, i.e. 44.
Balance of equipment represents accessory parts for use or for mount-
ing as required.
1. Rocker Arm Attachment (Universal Cone-type) - mounts on
forward stud on top table when operation is required.
2. Diamond Screw and Holder - mounts on rocker arm and dia-
mond dresser attachment to dress wheel. Remove top cone
assembly only.
3. "V" Rest - mounts on forward table stud and positioned for
(On
grinding butts of valves using side of grinding wheel.
models without butt grinder.)
Now that assembly has been completed, wipe the protective oil coating
from machine and prepare for lubrication.
LUBRICATION
TABLE WAYS: Position table for oiling ways by moving table to
the left as far as possible and fill center CUPS and R H cups. Move table
to right as far as possible and fill center CUPS and L H cups. There are
four spring cap type oil cups on top of table which should be filled and
maintained with (S A E No. 10) oil weekly. These cups oil bottom and top
table ways and rear bearing feed screw assembly.
FEED SCREW ASSEMBLY K403 AND K403C SERIES: The ball type
oil cup on front top of base cares for the front bearing of this unit. Oil
rear feed screw bearing by moving table to the front of machine exposing
oil hole in base. Fill with S A E No. 10 or equivalent. Also apply oil
directly on screw for easy operation.
FEED SCREW ASSEMBLY K500 AND K500C SERIES: Two alemite
fittings, 1--Top front for greasing bearings. 1 - feed nut accessible after
tank is removed from left side.
Page 2
