TM 9-4910-641-14&P
tecting base finish with soft wood block or rubber pad. Now remove
needle
lock spring by pinching open section together with
nose pliers, remove the lock spring then washer, and spacing collar.
Now remove the belt (see installation of belt) on the L H side spindle
housing. S p i n d l e p u l l e y r e m o v e s f r o m s h a f t b y l o o s e n i n g s e t s c r e w w i t h
wrench. Remove
lock spring, thin washer (s), thrust
s p r i n g s , a n d s p a c i n g c o l l a r l i k e the procedure followed to free R H side
bearing. To correct for slight variations in casting dimensions, thin wash-
To replace spindle and bearings, assemble by inserting from R H side
of housing, a n d p u s h i n t o p l a c e . Reversing
disassembling
process,
start
on L H side replacing spacing collar, thrust springs, thin washer (s) and
lock spring. Make certain that lock spring is properly
lock with
seated in the housing groove. Next place spacing collar, thin washer and
lock spring over shaft on R H side. Then using screw driver or
flat bar, place end against rear inside, of wheel guard exerting pressure
against the projecting shaft end (use soft wood block or rubber pad to
protect shaft end), forcing shaft as far to the left as possible against thrust
s p r i n g s . W h i l e a p p l y i n g p r e s s u r e position the spacing collar, thin washer,
lock spring which seats in housing
and lock spindle in place with
groove. S l i p w h e e l r a n g e o v e r s h a f t a n d t w i s t t o t i g h t p o s i t i o n .
COOLANT SOLUTION: This Soluble oil is made for use in any type
w a t e r . C o o l a n t t a n k m u s t b e c l e a n . Soluble oil should be at room tem-
perature. Shake well before using. Mix one ounce of soluble oil to each
quart of water. Always add oil to water. Never water to oil. After emul-
sion is formed water may be added. Oil should be added slowly with agi-
tation. It is important that mixture is thoroughly mixed. Maintain coolant
level with additional water until solution fails to prevent rust. At this
point it is advisable to thoroughly clean coolant tank, and prepare new
filling of coolant. Soluble oil can be obtained in
1 Qt. can No. 2659.
Page 4
