TM 9-4910-710-14&P
INTRODUTCTION
wheel dolly is alifting device designed to facilitate the
The model 80-G
removal and installation of heavy dual or single wheel assemblies on
such vehicles as trucks and buses.
A hydraulic jack raises the carriage
assembly of the wheel dolly up to the wheel after the vehicle has been
A large adjusting screw located above
raised and properly supported.
The lift
the rear caster provides exact tilt positioning of wheels.
Com-
arms roll on oilite bearings to make wheel rotation effortless.
plete maneuverability of the wheel dolly is provided by large rubber
tired casters.
Lifting roller length....30"
Capacity . . . . . . . . . . . . . . . . 1500 lbs.
Lifting arm spread . . . . . . . .24"
Hydraulic lift . . . . . . . . . . . . .5 1/2"
Caster diameter . . . . . . . . . . 4"
Extension screw adjustment . . . .1 3/4"
Net weig ht . . . . . . . . . . . . . . 150 lbs.
Chassis height . . . . . . . . . . . . . . 29 3/4"
Wheel diameter range . . . . . .9.00 x 16
Chassis width . . . . . . . . . . . . . . . 37 1/2"
to 14.00 X 24
Chassis length . . . . . . . . . . . . . . 39 3/4"
Every part of this wheel
Keep wheel dolly clean and well lubricated.
1.
dolly has been accurately machined and assembled, but frequent lubri-
cation is necessary.
Lubricate carriage rollers, lift arm rollers, casters
and
caster
2.
wheels regularly with SAE 30 weight motor oil or equivalent.
ONLY HYDRAULIC
FLUID
MIL-H-
DO
NOT
USE
HYDRAULIC
BRAKE
FLUID.
USE
1.
6083.
DESIGNED TO LIFT VEHICLE, AND MUST BE
MODEL 80-G WHEEL DOLLY IS NOT
2.
USED TO LIFT ONLY THE WHEEL ASSEMBLY.
3.
LIFT
VEHICLE
WITH
APPROPRIATE
LIFTING
DEVICE,
AND
SUPPORT
VEHICLE
WITH
SAFETY
STANDS
(TRESTLES,
MOTOR
VEHICLE)
BEFORE
STARTING
WORK,
INSPECTION,
OR
GETTING
UNDER
VEHICLE
FOR
ANY
REASON.
1
