TM 9-2330-381-14
4-79.
SUSPENSION CONTROL MANIFOLD (CONT)
DISASSEMBLY
CAUTION
A clean area must be maintained during disassembly of the suspension control
manifold or contaminates may enter one of the cartridges and cause premature
failure of the manifold.
1.
Remove five LBCG LCN cartridge valves (1) from suspension control manifold (2). Install caps/plugs into all
openings.
2.
Disassemble LBCG LCN cartridge valve (1) as follows:
a. Remove preformed packing (3), backup rings (4 and 5), preformed packings (6 and 7), and backup ring (8).
Discard preformed packings and backup rings.
b. Repeat step a as required for disassembly of remaining LBCG LCN cartridge valves (1).
3.
Remove CBCA LAN cartridge valve (9) from suspension control manifold (2). Install caps/plugs into all openings.
4.
Disassemble CBCA LAN cartridge valve (9) by removing preformed packing (10), backup rings (11 and 12),
preformed packings (13 and 14), and backup ring (15). Discard preformed packings and backup rings.
5.
Remove four FCCB XAN flow regulating valves (16) from suspension control manifold (2). Install caps/plugs into
all openings.
6.
Disassemble FCCB XAN flow regulating valve (16) as follows:
a. Remove preformed packing (17), backup rings (18 and 19), and preformed packing (20). Discard preformed
packings and backup rings.
b. Repeat step a as required for disassembly of remaining LBCG LCN flow regulating valves (16).
INSPECTION
WARNING
Cleaning compound solvent is used to clean parts and is potentially dangerous to
personnel. Extinguish all smoking materials and do not allow sparks or open
flame near the work area. Use skin and eye protection and work in a well-
ventilated area.
1.
Clean all tubes, fittings, attaching hardware, suspension control manifold and cartridge, and flow regulating valves
in degreaser tank with cleaning compound solvent.
4-390