TM 55-1925-283-12&P
0013 00
INSTALLATION
1. Install the 10 new filter elements (figure 2, item 7) by twisting them while pushing them onto the return tubes
(figure 2, item 8).
! CAUTION
Do not over tighten the cap screws. Over tightening of the cap screws will result in
breakage of the return tubes.
2. Install the 10 cap screws (figure 2, item 6) and tighten them lightly.
3. Install a new O-ring (figure 2, item 5) onto the fuel filter/water separator tank lip (figure 2, item 9). Apply a thin
coat of grease on the new O-ring.
4. Position the lid (figure 3, item 1) onto fuel filter/water separator tank lip (figure 3, item 2) ensuring that the
alignment arrows (figure 3, item 3) are properly aligned.
5. Position the retainer clamp (figure 2, item 3) over the joint (figure 3, item 4) between the lid (figure 2, item 4;
figure 3, item 1) and the fuel filter/water separator tank lip (figure 2, item 9; figure 3, item 2).
3
1
Line up arrows for proper fit
4
Line up arrows for proper fit
2
Figure 3. Alignment Arrows
0013 00-4