TM 9-2330-205-14&P
HANDBRAKE CABLE ASSEMBLY
This task covers:
INITIAL SETUP
.
Materials/Parts
Tools
.
Cotter pin
Handle, reversible, 3/8-inch square
drive
Equipment Condition
Pliers, diagonal-cutting
Screwdriver, cross-tip
Socket, 1/2- by 3/8-inch square
drive
Wrench, open-end, 7/16-inch
Wrench, open-end, 1/2-inch
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
NOTE
This procedure is typical for both sides.
Cotter pin (2) and
Using pliers, remove.
Handbrake
1.
clevis pin (3)
Discard cotter pin (2).
cable (1)
Two nuts (5), two
Retaining
Using 1/2-inch open-end and socket
2.
Iockwashers (6), and
wrenches, remove.
strap (4)
Retaining strap (4) and spacer (8)
two capscrews (7)
should fall off.
Clamp (10), nut
Using 1/2-inch open-end wrench and
Cable clamp
3.
(11), washer (12),
screwdriver, remove.
mounting
and screw (13)
bracket (9)
Handbrake cable (1)
Remove.
Internal
4.
lever (14)
Two nuts (16), clamp
Backing plate (15)
a. Using 7/16-inch wrench, loosen nuts (16).
5.
(17), and handbrake
b. Pull out handbrake cable (1).
cable (1)