TM 9-2330-285-14&P/TO 36A11-21-10-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. ONE OR MORE (BUT NOT ALL) LAMPS FAIL TO LIGHT, ARE DIM, OR FLICKER
Step 1. Check fuses and circuit breakers in the towing vehicle.
Replace bad fuses or reset tripped circuit breakers (refer to
applicable TM). If fuses and circuit breakers are good, go to
step 2.
NOTE
The following references are needed for step 2:
Step 2. Check for faulty lamps or corroded lamp sockets.
a. Remove affected lamp(s) from light(s) and test with a
b. Replace faulty lamp(s). If lamp(s) are good, leave the light(s)
disassembled and go to (c).
c. Clean corroded lamp sockets (page 4-22). If sockets are clean,
go to step 3.
Check the line that powers the affected lamp(s) for continuity between the
Step 3.
intervehicular cable, junction box, resistors, interdolly cable, rear
4-15