TM 9-2330-386-14&P
4-25 LIGHT SWITCH.
This task covers removal and installation.
INITIAL SETUP
Tools
General mechanics tool kit
WARNING
Disconnect all electrical power before performing any
maintenance on the electrical system. Failure to do so
could result in injury.
CAUTION
Don't allow nose plate to drop or hang by wires. Support
n o s e plate to prevent damage to wires, connectors, and
tubing.
NOTE
If circuit marker bands are missing or not readable, tag
wire leads.
a. Removal.
( 1 ) Remove f o u r c a p s c r e w s ( 1 ) a n d c a r e f u l l y p u l l n o s e p l a t e ( 2 ) a w a y f r o m
frame. Support nose plate (2).
(2) Loosen three screws (3) and remove connectors (4) from switch (6)
terminals.
(3) Remove nut (5) and switch (6).
.
b.Installation.
(1) Install switch (6) on nose plate (2) and position nut (7) as necessary.
Be certain that switch toggles from side to side.
(2) Install and tighten nut (5).
(3) Install three connectors (4) on switch (6) terminals according to marker
b a n d s , as shown.
(4) Tighten three screws (3).
4-42