TM 9-2330-386-14&P
4-26 LIGHT RESISTORS (CONT) .
a. Removal.
WARNING
Disconnect all electrical power before performing any
maintenance on the electrical system. Failure to do so
could result in injury.
CAUTION
Don't allow nose plate to drop or hang by wires. Support
n o s e plate to prevent damage to wires, connectors, and
tubing.
NOTE
If circuit marker bands are missing or not readable, tag
wire leads.
(1) Remove four capscrews (1) and carefully pull nose plate (2) away from
frame. Support nose plate (2).
(2) Disconnect wire assembly (3) from resistors (8) terminals.
(3) Pull two connectors (4) from resistors (8) terminals.
(4) Remove two nuts (5), lock washers (6), washers (7), and resistors (8).
(5) Pull two connectors (9) and wire assembly (10) from resistors (12)
terminals.
(6) Remove two screws (11) and resistors (12).
(7) Pull two connectors (13) and wire assembly (14) from resistors (18)
terminals.
(8) Remove two nuts (15), lock washers (16), and washers (17).
(9) Remove resistors (18) and screws (19).
b . Installation.
(1) Install two screws (19), resistors (18), washers (17), lock washers (16),
and nuts (15) and tighten.
(2) Connect wire assembly (14) and two connectors (13) to resistors (18)
terminals, as shown in illustration.
(3) Install two screws (11) through resistors (12) and position on nose plate.
(4) Install resistors (8), washers (7), lock washers (6), and nuts (5) and
tighten.
4-44