C4, TM 9-2350-230-12
TABLE 2-3. STARTING, DRIVING, AND STOPPING VEHICLE - Continued
STEP
PROCEDURE
REFERENCE
STARTING ENGINE
13
Depress service brake pedal and pull out and up on parking BRAKE
LOCK handle to set brake.
14
Place water steer lever in LAND position
WARNING: Be sure water steer lever is in LAND position to
prevent damage to transmission and possible loss of vehicle control.
15
Place transmission shift lever in N(neutral) position
CAUTION: Make certain that neutral safety switch roller con-
tacts transmission shift control lever near center of actuating end
when in N (neutral) position but is open in all other shift positions.
16
Turn SPEED/RPM indicator switch to RPM position
17
Make sure fuel shutoff knob is pushed in
18
Press ENGINE STARTER switch to START position
CAUTION: Do not operate starter over 15 seconds. If engine
does not start, refer to troubleshooting procedure, table 5-1, steps
1 and 2. Allow 5 minute cooling-off period before again attempting
to start.
19
When engine starts, pull out hand throttle control knob and set to
CAUTION: During engine warm-up, refer to indicator panel
checkout procedure.
20
Turn SPEED/RPM indicator switch to SPEED position
DRIVING VEHICLE ON LAND
CAUTION: Until the driver becomes familiar with the vehicle,
every precaution must be taken not to over-drive or allow loss of
vehicle control. Make certain that gun is straight forward when
traveling through wooded areas to prevent damage to grenade pro-
jector mounts.
WARNING: Do not coast down grade. Keep engine speed matched
to vehicle speed to avoid losing steering capability.
21
Apply pressure on brake pedal, pull out and down on parking BRAKE
LOCK handle to release brake.
22
With brake pedal depressed, hand throttle control knob pushed in,
shift from N (neutral) to desired range.
23
Release brake pedal and depress accelerator pedal to attain desired
vehicle speed.
2-8