TM 9-2350-277-10
OPERATE AN/VAS-5 DRIVER'S VISION ENHANCER (DVE) (M58 ONLY) -- Continued
0035 02
4.
Set DVE POWER switch to OFF (down position).
5.
Set VIDEO switch to SENSOR (up position).
6.
Set POLARITY switch to WHT-HOT (up position).
7.
With DISPLAY BRIGHTNESS control turned fully counterclockwise, rotate knob approximately 1/4 turn clockwise.
8.
Set SENSOR LEVEL and GAIN controls to full counterclockwise (AUTO) detent position.
OPERATE
WARNING
Before operating the vehicle, ensure that the DVE azimuth control is in the locked position.
This will ensure that the DVE is looking straight ahead when operating the vehicle. Failure to
do so may result in personnel injury and/or damage to the equipment.
WARNING
Helmets must always be worn when driving with the DVE installed. The DVE display should
be removed from its mount when not in use for extended driving operations to minimize the
risk of head strike injuries.
NOTE
Refer to Description and Use of Operator's Controls and Indicators for control locations
Ensure the VEHICLE MASTER POWER switch and the DVE POWER switch are set to ON.
1.
Change 4