Section VIII. CONTROL ASSEMBLY
3-106. General.
3-110. Replacement of Directional Control Valve
3-107. This section contains instructions for removal
Linkage.
and installation of the control assembly.
3-111. Removal and Installation. Refer to figures
3-108. Description.
3-46 and 3-47 for instruction removal and installation of
directional control valve linkage.
Follow the
3-109. The bulldozer control assembly is located in the
alphabetical sequence of views for removal and the
driver's compartment in the forward section of the hull.
numerical sequence of views for installation.
The control assembly handle is connected by
3-112. Replacement of Box Assembly.
mechanical linkage to the directional control valve. The
mechanical linkage consists primarily of connecting
3-113. Removal and Installation . Refer to figures
rods, which are terminated with clevises and link arms
3-48 through 3-50 for instructions on
removal and
which are used to change the direction of travel of the
installation of box assembly. Follow the alphabetical
rods. Where the connecting rod passes through the
sequence of views for removal and the numerical
hull, the opening is waterproofed by means of a sleeve,
sequence of views for installation.
bushing, and seal.
3-62