TM 9-4120-395-14&P
This task covers:
a. Inspection
b. Testing
c. Removal d. Installation
INITIAL SETUP:
Tools:
Tool Kit, service, refrigeration unit
Equipment Conditions:
Power off at power source.
Bot,1 front door assemblies removed. See para 4-17.
General Safety Instructions:
Disconnect input power to the unit before performing any internal maintenance.
Voltages used can kill. Shutting the unit off at the thermostat does not disconnect
unit power.
a. Inspection.
(1) Check the two screws (1, Figure 4-22) and strap (2) attaching the compressor capacitor (3) to the dividing
wall assembly (4). Tighten if required.
(2) Install both front door assemblies. See para 4-17.
b. Testing.
(2) Install both front door assemblies. See para 4-17.
c. Removal.
(2) Loosen the two screws (1) holding the strap (2) to the dividing wall assembly (4).
(3) Remove the compressor capacitor (3) from the air conditioner.
d. Installation.
(1) Slide the compressor capacitor (3, Figure 4-22) under the retaining strap (2) on the dividing wall assembly
(4).
(2) Tighten the two retaining screws (1) on the retaining strap (2).
(3) Connect the wires as tagged and remove the tags. Place rubber boot back over capacitor (3).
(4) Install both front door assemblies. See para. 4-17.
4-38