TM9-4120-400-14
MIST ELIMINATOR. - continued
4-16.
INSTALLATION
1. TOP marking must be up and airflow arrows, located on side or bottom, must point outward away from coil.
2. Slide mist eliminator (3) down into mounting frames observing airflow arrows and top marking.
3. Install top front panel (2) and secure with eight screws (1).
NOTE
FOLLOW-ON MAINTENANCE:
Connect power at power source.
d. Replacement
c. Adjustment
b. Inspection
a. Cleaning
This task covers:
INITIAL SETUP
Tools
Equipment
Condition
Refrigeration Unit Service Tool Kit
Scrub Brush
General Safety Instructions
Materials/Parts
Detergent
Do not tamper with cylinder or refrigerant tubing
Rags
connections. If actuating cylinder is suspected bad,
notify supervisor.
Lock washer
Cotter Pins (5)
CLEANING
Clean the louver assembly with a soft brush or wash with water and a mild detergent solution.
INSPECTION
Check louver for bent blades(6), missing or damaged gaskets, and missing hardware or bearings.
1.
2.
Clean linkage with a soft brush and damp rag.
Check push-pull cable attaching hardware (mechanical post and screws etc.) for tightness.
3.
4-49