INFORMATION PLATES. - continued
(1) Riveted information plates.
(a) Drill out rivets using a drill bit slightly smaller than the rivet. Use a drill stop or similar tool to avoid
damage to internal parts.
(b) Install new plate and secure with proper size rivets.
(2) Self-adhesive information plates.
(a) Pull plate off and remove as much adhesive from unit as possible by pulling or scraping it off
Adhesive remover is flammable and the vapors can be explosive. Keep away
from sparks or flame.
Repeated or prolonged skin contact or inhalation of vapors can be toxic. Use in a
well ventilated area and wear gloves.
(b) Soften and remove old adhesive using adhesive remover and a stiff brush.
(c) Peel backing off new plate and position in place on unit. Press into firm contact all over.
Connect power at power source.