TM9-2330-376-14&P
4-44. HUB, BRAKEDRUM, AND WHEEL BEARINGS MAINTENANCE (Con't).
f.
WHEEL BEARING ADJUSTMENT
1.
Install nut (7). Fully tighten nut while rotating hub (8) in both directions until hub will not move with hand pressure.
Back off nut 1/4 turn and install keywasher (6) and nut (5). Bend one tab on keywasher over nut (5).
2.
Install new gasket (4) and hubcap (3) on hub (8) with three screws (1) and new Iockwashers (2).
3.
Place floor jack under end of axle and remove jackstand.
FOLLOW-ON TASKS:
Apply handbrakes.
4-45. TIRE AND WHEEL MAINTENANCE.
Refer to TM 9-2610-200-14 for tire and wheel maintenance procedures.
TA700984
4-84