TM 9-2330-381-14
5-24.
GOOSENECK/PIVOT PIN (CONT)
2.
Apply antiseize compound to inner surfaces of bearing (23), exterior of curbside pivot pin (21), and inner surfaces
of pivot pin mount in platform.
CAUTION
Hammer against a piece of wood when driving in pivot pin or damage to equipment
may result.
NOTE
While driving either pivot pin into platform, observe pivot pin through key slots in
platform. If pivot pin keyway does not aline with key slots in platform or gets
rotated during installation, the pivot pin must be removed, re-alined, and re-
installed.
3.
Make sure keyway in curbside pivot pin (21) is alined with key slots in platform. Using a sledge hammer and
piece of wood, drive curbside pivot pin (21) to inboard edge of bearing (23).
NOTE
Grease will help to hold spacer in place during installation.
4.
Apply grease liberally to spacer (22) and install between inboard edge of curbside pivot pin (21) and platform.
Make sure spacer (22) is alined to allow curbside pivot pin (21) to be driven through spacer (22) into platform and
continue driving curbside pivot pin (21) into platform.
5.
Apply antiseize compound to inner surfaces of bearing (23), exterior of streetside pivot pin (17), and inner
surfaces of pivot pin mount in platform.
5-124