TM 11-5820-489-10
TO 31R4-2GRA6-31
Turn unit over so battery compartment
q
is now on the bottom. Locate Bell/Lamp
switch. Set the Bell/Lamp switch in
either Bell or Lamp position
according to your need.
Replace the case. Tighten both
q
thumb screw fasteners.
c. Local Control Connection
If the unit is to be installed alongside or
q
near the radio set and connected to front
panel (not mounted), proceed as follows:
NOTE
Turn power OFF on the radio set before
connecting the Local Control Unit.
At the rear, open the cable
q
compartment cover by pressing
the latch at the top and laying
cover down. Bring the two
cables out.
NOTE
Pull cables through case before closing case.
